What Is Rigging?
Rigging adds a controllable skeleton and handles to a model so that it can be posed and animated. Think of a puppet with strings.
Bones
- Go to the Create tab, then Systems > Bones
- Click in a side view to place joints one after another
- Right-click to end the chain
- Name the bones, for example
Arm_Upper,Arm_Lower,Hand
FK and IK
| Type | How it works | Best for |
|---|---|---|
| FK (Forward Kinematics) | Rotate each joint from the parent down | Arcs and swings, like arms swinging |
| IK (Inverse Kinematics) | Move the end handle and the chain follows | Feet planted on the floor, hands holding objects |
Add an IK Solver
- Select the first bone of a chain
- Choose Animation > IK Solvers > HI Solver (History-Independent) and click the end bone
- Move the IK handle to pose the chain
- Use a Preferred Angle on the knee and elbow so the joint bends the right way
Controls
Create simple controller shapes such as circles or boxes, link the IK handles to them, and animate only the controls. This keeps the rig clean.
Two-Bone IK Maths
elbow interior angle: 119.1 degrees | shoulder offset angle: 29.3 degrees | max reach: 58.0 cm
To reach 50 cm with 30 cm and 28 cm bones the elbow bends to about 119 degrees. The target cannot be farther than 58 cm, the sum of both bones, or the arm will fully straighten.
Practice
- Make a three-bone arm and pose it with FK
- Add an HI Solver and pose with the IK handle
- Make a leg that keeps its foot on the floor
- Link a controller to the IK handle
Conclusion
Bones give structure, FK gives swing and IK gives control of the end of a chain. Use controls for clean animation.

