What Is Skinning?
Skinning binds a model to a skeleton, so when the bones move, the surface moves with them. The Skin modifier stores how strongly each vertex is influenced by each bone. Those numbers are called weights.
Steps
- Select your model and add the Skin modifier
- Click Add under Bones and pick the bones
- Move a bone and look at the result
- Fix problems with envelopes and weights
- Test with extreme poses
Weights
Each vertex has weights that add up to 1. A vertex near an elbow might be 50 percent upper arm and 50 percent lower arm.
weight to A: 1.0 -> position (10.0, 0.0) | weight to A: 0.75 -> position (9.0, 1.5) | weight to A: 0.5 -> position (8.0, 3.0) | weight to A: 0.25 -> position (7.0, 4.5) | weight to A: 0.0 -> position (6.0, 6.0)
A vertex with weights of 0.5 and 0.5 ends up halfway between the two positions. Changing weights smoothly makes smooth bends.
Paint Weights
- Turn on Weight Tool or Paint Weights and set Value and Size
- Use Add to add influence and Subtract to remove
- Use Smooth to soften sharp weight transitions
- Use Mirror to copy weights from one side to the other for symmetric models
- Turn on a Skin Hotkey such as Paint Weight if you assigned one (3ds Max 2026 added a hotkey for it)
Common Problems
| Problem | Fix |
|---|---|
| Mesh collapses at the elbow | Add more edge loops around the joint and smooth weights |
| Candy-wrapper twist at the wrist | Add twist bones and share the twist between them |
| Parts follow the wrong bone | Check envelopes and use Paint Weights to remove influence |
| Heavy rigs | Limit bones per vertex, usually to 4 |
Practice
- Skin a cylinder to three bones
- Paint weights so the bend is smooth
- Mirror weights on a symmetric arm
- Fix a collapsing elbow by adding edge loops
Conclusion
Skinning connects mesh to bones through weights. Smooth weights and good topology make good bends.

